|
|
 |
I've seen many different designs for kitchen organizers
but this design seemed to blend in with the style of my kitchen. It's made
of red oak with a lacquer finish. The base, back and sides are 1/2" and
the dividers and draws are 1/4" thick.
Routing all the grooves for the dividers is really easy
with a router table. |
 |
Many of the cuts here will be plunge cuts. Be sure to
mark the fence to reflect where the sides of the bit are, and to mark where
cuts begin and end on the reverse side. I used a 1/4" bit for all cuts
here, I just made a couple of passes for the 1/2" stock. Be sure to use
a backer piece where the bit exits the stock, to prevent tear out. |
 |
I like to use epoxy when assembling small projects like
this. It's very strong, acts as a void filler, and if some epoxy shows
up after it's dry it blends in with clear finish nicely! No need to dig
into the corners to sand it off. Make sure to stay away from the "5 Minute
Epoxy", that stuff is junk! Get the 24 Hour stuff! Sometimes it's called
"2 Ton Epoxy".
T-88
is another good epoxy. |
 |
The draws are made from the same red oak. I took 3/4"
stock, resawed it on the table saw, then cleaned up the saw marks and sized
it to 1/4" in my planer. You
can purchase 1/4" stock at many home centers, etc.
Shape the front of the draws as in the pic at left. I
traced a qt. can for the radius. |
|
!!!