Roller Blade Ramp
4/01
Helmets and pads are a must!!!
 |
 |
 |
Yes this was a fun project, mostly because my active son was able to slow down enough and really get into the sawdust! He was involved in the design on paper, making the templates, cutting parts and bending plywood...his favorite part! |
 |
There are two ramps each 31" wide and 5'6" long, with a height if 16" at one end. The support comes from two 2x8s cut to the curved shape, with ribs every 8" connecting them. Two layers of 1/4" plywood are stapled down with a layer of construction adhesive between them. |
 |
 |
Taking a much needed break....I hope! |
This kid never stops! Now if i could only get him to wear his pads! |
| The plans are here! | |
| Click here to see Johnnys Skateboarding World! | |
|
|
|
|
|
|
|
|
|
|
||
|
|
Plans |
|